Stitchboard Admin message #2
Re: Bead loom pattern creation - stitches to inches
October 20, 2017 at 10:09:50 PM  (in response to taratears message #1)
 
taratears,

Welcome!

With the current version of the software you can specify the number of stitches (beads) across, but what you can't do is specify the number of beads down; that will be addressed in a later build of the software, which is currently under development. The reason we didn't originally allow for vertical specifications was that we were worried people would either truncate or skew their patterns.

What you can do is key your image to be the correct number of pixels = beads for 2 inches across, then use trial and error to add borders to your image so you can get the vertical to the correct number of beads.

---